A PHP Error was encountered

Severity: Notice

Message: Undefined index: HTTP_ACCEPT_LANGUAGE

Filename: helpers/varios_helper.php

Line Number: 187

A PHP Error was encountered

Severity: Notice

Message: Undefined index: HTTP_ACCEPT_LANGUAGE

Filename: helpers/varios_helper.php

Line Number: 187

R.A. Ingeniería

HOLCIM

Calculation and design of support structure for shell cutting and tyre replacement.

Adequation of loads to seismic scenario.

Calculation and design of saddles for shell cutting and tyre replacement.

Adequation of loads to seismic scenario.

Finite elements analysis (FEM) for girth gear flange. Cement mill. Diagnosis and conclusion.

Finite elements analysis (FEM) for girth gear flange. Cement mill. Diagnosis and conclusion.

Repair of the new cement mill. Calculation and designs of the girth gear flange welding.

Cálculo y diseño de nuevas soldaduras para brida de corona de accionamiento.

Project revision of the new cement mill structure, verifying seismic condition.

Elevator structure, belt conveyors, hot gases generator, alkalis hopper, travelling crane and filter pipes supports.

Raw pneumatic transportation system project to raw silos.

General inspection of kiln number 1. Diagnosis, conclusions and recommendations.

Finite element analysis

FEM of the girth gear welds, recommendations to correct them during new mill mounting. New mill from china.

Calculation of the necessary power for the new mill production.

Project of new conveyor belt for material extraction from the crusher.

Cold axis alignment measurement after the replacement of tire number 2.

Assistance for moving the rollers to achieve alignment and thrust for the start up.

Seismic analysis for the support tower for shell cutting to replace tire number 2.

Finite element analysis to calculate the stress for the different sections of the kiln, to identify

Mediante elementos finitos para identificar zonas de futuras fisuras.

Shell cutting analysis for the kiln, to solve the problems at the inlet seal.

Calculation of the compressor capacity and comparison with other factories for industrial tests for

Obtención del mismo de otra fábrica del grupo para prueba industrial de quemado de fluorita.

Study of the heating procedure for tire repair and welding. Finite element calculation to avoid furt

Development of technical specifications for tyre replacement.

Pre – selection of tire, shell, and mounting supplier.

Cooling tower: Analysis of causes of recurring corrosion at the top of the tower.

Recommendations for modifications of the spray system.

Study of vibrations in cement separator using finite element.

Project to reinforce the supporting structure and resolve the lack of rigidity.

Local supplier inspection for a vented girth gear cover.

Adequacy project of fluorite and limestone hoppers to seismic situation without interrupting product

IIncremental improvements study for kiln number 1.

New inlet seal system, assistance in recovering the girth gear and hot and cold alignment measurements (Phillips). Incorporating axial hydraulic thrust.

Alkalis By-Pass Project for kiln number 1.

Design and economic evaluation for a reverse air filter moving: from Panqueua - Capdeville Mendoza -

Hydraulic hammer rock breaker at the entrance of the primary crusher. Project implementation.

Recovery and increasing capacity project of two metal silos for cement. Seismic calculation.

Economic evaluation and design of cement bagging and palletizing sectors.

Insertion in the factory Lay Out

English| Español| Português © 2003 - 2024 R.A Ingeniería S.A.